TV Unit Interior Design in Hyderabad: Sizes, Materials, and Design Styles
The TV unit anchors the living room visually and functionally. Size it to the room, not the TV — and specify the right materials before the carpenter begins, not after.
AlcorOne Solutions is a Hyderabad-based interior execution studio specialising in residential and commercial fit-outs across Gachibowli, Kondapur, Kokapet, and the Financial District. All work is manufactured in-house and assembled on site — no subcontracting, no surprise substitutions mid-project.
TV Unit Sizing: Start With the Room, Not the TV
The most common TV unit mistake in Hyderabad apartments: sizing the unit to the TV panel, not to the wall. A 55-inch TV on a 1,200 mm unit looks stranded. The unit should read as a wall composition — the TV is one element within it, not the only element.
A practical rule: the TV unit width should be 1.5–2× the TV diagonal in centimetres, with the TV panel occupying the central one-third to one-half of the unit width. Flanking sections hold open shelves, cabinets, or fluted panel infills.
| TV Size | Recommended Unit Width | TV Centre Height from Floor |
|---|---|---|
| 43 inch | 1,500–1,800 mm | 880–980 mm |
| 50 inch | 1,700–2,000 mm | 900–1,000 mm |
| 55 inch | 1,800–2,200 mm | 950–1,050 mm |
| 65 inch | 2,200–2,600 mm | 1,000–1,100 mm |
| 75 inch+ | 2,600–3,000 mm | 1,050–1,150 mm |
Height of the unit: Floor-to-top-of-unit is typically 450–550 mm for a low-profile floating unit, 650–800 mm for a floor-standing unit with a bottom cabinet. Full-height wall panelling (floor to ceiling) is a different scope — it incorporates the TV zone, flanking shelves, and runs to the false ceiling, creating a unified wall.
Depth: 400–450 mm for units with a bottom storage cabinet. 300–350 mm for open-shelf or floating styles. The back panel recess (where the TV sits) can be 50–75 mm shallower than the side cabinets to create a layered depth effect.
Full-Height vs Low-Profile: Which to Choose
In Hyderabad apartments with 9.5–10 ft ceilings, full-height TV wall panels are increasingly popular. They eliminate the visual gap between joinery and ceiling and give the living room a built-in, permanent look. Cost is higher (₹1,20,000–2,20,000 vs ₹50,000–90,000 for a low-profile unit), but they also provide significant additional storage in the upper sections.
Low-profile floating units suit smaller living rooms where a full-height unit would overpower the space. They also suit rental-friendly setups — they can be removed cleanly without wall damage.
Carcass: Plywood Grade and Thickness
The carcass (the structural box of the unit) is where material quality matters most. Shutters and finishes are visible; the carcass determines whether the unit lasts 5 years or 15.
Material Grades: Choosing the Right Plywood
Selecting the wrong wood grade for a specific area is the primary cause of premature interior failure. Here is the full hierarchy:
| Grade | Standard | Water Resistance | Best Used For |
|---|---|---|---|
| BWP (Marine Ply) | IS 710 | Boiling water — no delamination | Kitchen sink cabinet, utility storage, bathroom vanities, wet-wall units |
| BWR Plywood | IS 303 | High humidity + splashes | Kitchen wall cabinets, dining crockery units, dry overhead storage |
| Commercial / MR | IS 303 (MR) | Humidity only — no direct water | Bedroom wardrobes, TV units, study desks |
| HDHMR | — | High moisture resistance | Wardrobe shutter doors, kitchen shutters (high-gloss / PU finishes) |
| MDF / Particle Board | — | Poor — swells permanently | Low-wear vertical partitions only; avoid in kitchens entirely |
Rule: BWP IS 710 for any unit within 1 metre of a water source. BWR IS 303 for wall cabinets above the splash zone. Commercial MR for all dry rooms.
For a living room TV unit: Commercial MR IS 303 plywood, 18 mm for all structural panels (top, bottom, sides, vertical dividers). Shelves: 18 mm for spans over 600 mm, 12 mm for shorter spans. Back panel: 9 mm commercial ply or 6 mm MDF — both are adequate for a dry room.
Avoid particle board for the carcass. Hyderabad's humidity (70–85% relative humidity in June–September) causes particle board to swell at joints within 2–3 monsoon seasons, especially in ground-floor and lower-floor apartments.
Shutter Finishes: What Each Option Actually Means
| Finish | Durability | Maintenance | Cost (per sq.ft) | Best For |
|---|---|---|---|---|
| Laminate | High | Low — wipe clean | ₹180–320 | Most living rooms; matte or wood textures |
| PU Paint | High | Medium — marks show | ₹350–600 | Premium, flat-colour look |
| Acrylic | Medium | High — fingerprints | ₹400–700 | High-gloss feature sections |
| Veneer | Medium–High | Medium | ₹450–800 | Natural wood look, dining-adjacent units |
| Membrane/PVC foil | Medium | Low | ₹220–380 | Budget alternative to PU |
The most practical choice for Hyderabad apartments: matte laminate on the carcass body + PU or acrylic on the feature section (the panel section immediately around the TV). This gives you a premium focal point without paying PU rates for every square foot of cabinetry.
Hardware: Hinges, Channels, and Handles
Hardware: Blum vs Hettich vs Häfele vs Ebco
| Brand | Origin | Best Known For | Price Tier |
|---|---|---|---|
| Blum | Austria | Tandem drawer systems, Servo-Drive, Legrabox | Premium |
| Häfele | Germany | Concealed hinges, synchronised sliding systems, full fit-out catalogue | Premium |
| Hettich | Germany | InnoTech drawer systems, Quadro runners, soft-close hinges | Mid–Premium |
| Ebco | India | Channel slides, budget hinges, wardrobe accessories | Mid |
| Godrej | India | Locks, storage accessories, basic drawer channels | Entry–Mid |
Practical rule: Invest in Blum or Hettich for the kitchen (daily-use drawers and pull-outs). Ebco or Hettich is adequate for bedroom wardrobe hinges and shelves.
For a TV unit specifically: soft-close hinges on all shuttered cabinets (Hettich or Blum, minimum 35 mm cup size). Drawer channels if the unit includes a drawer — full-extension, soft-close, 40 kg load rating minimum. Handles: D-pulls or recessed edge pulls in brushed brass or matte black are the dominant choice in 2025–26 Hyderabad interiors.
Wire Management: Plan Before the Unit Goes In
This is the detail most homeowners regret skipping. Once the TV unit is built and the wall is finished, adding a cable management sleeve costs ₹4,000–10,000 and leaves visible marks. Before the carpenter begins:
- Run a 63 mm PVC conduit through the TV wall from the power socket position to the TV mounting point
- Run a second conduit from the set-top box or streaming device position to the TV wall (for HDMI cables)
- Mark the exact position for the wall-mount bracket before any joinery goes up — the bracket base needs to anchor into the wall, not into the plywood back panel
- Install a dedicated 6A socket inside the TV unit cabinet for the router, set-top box, and OTT device — this keeps all cables contained within the unit
Design Styles Popular in Hyderabad (2025–26)
The most-requested TV unit styles seen in Hyderabad apartments this build season:
- Fluted panel backdrop — vertical fluted MDF or WPC panels behind the TV, flanked by open floating shelves. Warm walnut or grey oak tones are most common.
- Full-height bookmatched wall — veneer or PU-lacquered panels from floor to ceiling, TV recess centred, integrated shelves above and beside.
- Dual-tone low unit — bottom cabinet in a dark tone (charcoal, espresso), floating shelf above in white or cream, TV mounted on a painted or textured wall rather than a panelled backdrop.
- Japandi minimal — light oak laminate, open shelves only, no upper cabinets, clean horizontal lines. Works best in rooms with natural light on the same wall.
What a TV Unit Costs in Hyderabad (2026)
| Type | Width | Finish | Indicative Cost |
|---|---|---|---|
| Low-profile floating unit | 1,800–2,100 mm | Laminate | ₹45,000–65,000 |
| Floor-standing with cabinet | 2,000–2,400 mm | Laminate + PU mix | ₹65,000–95,000 |
| Full-height wall panel | Wall-to-wall | PU / veneer | ₹1,20,000–2,20,000 |
| Fluted backdrop + floating shelves | 2,000–2,600 mm | Fluted MDF + PU | ₹75,000–1,30,000 |
Basis: AlcorOne execution rates as of , exclusive of GST. Indicative range for planning; the binding figure comes from an itemised BOQ against the actual site measurements and specification.
Written by Gogineni Kalyaan Kumar
Kalyaan is Principal at AlcorOne Solutions, the interior contracting firm he co-founded in 2022. He has overseen 80+ turnkey residential, villa, and commercial fit-outs across Chennai, Hyderabad, Bengaluru and Vizag, with a focus on itemised BOQs, heavy-duty modular execution, and durable interior systems built for South India’s climate.
Sources & references.
Standards, regulatory registries, and manufacturer references that back the material grades, pricing framework, and compliance points in this guide:
Frequently asked questions.
What is the right TV unit height for a 55-inch TV mounted on the wall?
The TV centre should be 950–1,050 mm from the floor when seated on a standard sofa (seat height 420–450 mm). For a wall-mounted 55-inch TV, the bottom edge of the screen ends up roughly 750–870 mm above the floor — which feels slightly higher than eye level when seated, which is correct.
Can I use particle board for a TV unit carcass to save cost?
Particle board is not recommended for Hyderabad apartments. The city's monsoon humidity causes particle board to swell at joints within two to three years, especially on lower floors. Commercial MR plywood at 18 mm is the minimum recommended standard.
What is the difference between a laminate finish and a PU finish for a TV unit?
Laminate is a pre-finished sheet bonded to the plywood surface — durable, scratch-resistant, and low-maintenance. PU (polyurethane) paint is sprayed in a factory or on site — it gives a smooth, solid-colour look that photographs well but shows marks more easily and costs 60–80% more per square foot than laminate.
How much does a full-height TV wall panel cost in Hyderabad?
Full-height TV wall panels (floor to ceiling, with integrated shelves and a TV recess) typically cost ₹1,20,000–2,20,000 in Hyderabad for a standard 3BHK living room wall, depending on finish, hardware, and unit depth.
Do I need a dedicated electrical socket inside the TV unit?
Yes. A dedicated 6A socket inside the cabinet keeps all set-top box, router, and OTT device cables contained within the unit. Running them externally to a wall socket adds visible cable runs that are difficult to manage neatly.
A well-specified TV unit takes one detailed conversation and an accurate site measurement. A poorly specified one means calls at the factory about material substitutions, and rework once the unit is on site. Get the brief right before anything is cut.
AlcorOne builds all joinery in-house and provides a complete BOQ — material grades, hardware brands, finish specifications — before work begins. You approve it, we build it exactly as approved.
Want a line-item quote for your TV unit?
We specify every ply grade and fitting in writing before we begin — no surprises mid-build.